Често срещани проблеми

Отстраняване на неизправности

Има някой проблеми при използването на металотърсачи, които могат да бъдат решени от потребителя доста лесно и затова тук ще Ви представим най-често срещаните.

ПРОБЛЕМ РЕШЕНИЕ

Няма захранване

1. Убедете се дали батериите са сложени и дали да сложени по правилен начин.
2. Сменете батериите с нови. Ползвайте батерии, които са предвидени да се ползват от фотоапарати, в смисъл не ползвайте най-евтините батерии за теливизионно дистанционно.


Непостоянен звук или постоянно движение на курсорът – Target ID

1. Ensure your searchcoil is securely connected and the coil is tightly wound around the stem
2. Ensure you are not using the detector indoors or where excessive amounts of metal are found
3. Reduce your sensitivity setting
4. Determine if you are close to other metal detectors or other metal structures such as electrical power lines, wire fences, benches, etc.

(NOTE: Iron targets may cause erratic sounds or Target ID Cursor movement. You can identify iron targets in an All-Metal Mode)


Прекъсващи сигнали

Intermittent signals typically mean you’ve probably found a deeply buried target or one that is positioned at a difficult angle for your detector to read. Increase the sensitivity on your detector and scan from different directions until the signal becomes more definite. In the case of multiple targets switch to the All-Metal Mode or press PINPOINT to precisely locate all targets.

(NOTE: Iron targets may cause Intermittent Signals. You can identify iron targets in an All-Metal Mode).


Не намирам целта, която съм засекъл Ensure you are using the correct mode for the type of hunting you are doing. If you are hunting for coins, ensure you are in the COINS mode. You may also use the All-Metal mode, which detects all metal targets to ensure desired targets are present.

Курсорът Target ID отскача и се движи нервно If your Target ID Cursor bounces erratically, chances are you’ve found a trash target. However, a Target ID Cursor may bounce if a good target (such as a coin) is not parallel to the searchcoil (e.g. on edge). It may also bounce if there is one or multiple “junk” targets laying next to the good target. Scan from different directions until your Target ID Cursor becomes more stable.